Challenger intruder alarm manual

AP10LED Engineering Manual 5 Section 1 - Overview of System The 10 zone intruder alarm system is an indoor alarm system based on advanced technology to give professional levels of protection and reliability. It is 10 zone wired system with special electronic design for . This manual is a reference for the Challenger operations and programmingthat can be done via RAS. Use management software for advanced operations and Routine maintenance on intruder alarm systems installed in a client’s premises should be performed in accordance with AS SECTION 5. MAINTENANCE, RECORDS AND REPORTS. This manual is a reference for the Challenger operations and programmingthat can be done via RAS. Use management software for advanced operations and Routine maintenance on intruder alarm systems installed in a client’s premises should be performed in accordance with AS SECTION 5. MAINTENANCE, RECORDS AND REPORTS.

1 Engineer Reset on Any Alarm (see section , page 23) Off 2 Engineer Reset on Tamper Alarm (see section , page 23) Off 3 Disable User Ability to Omit Tamper Off 4 Code PIN Tamper (tamper alarm after 16 invalid key presses when unset) Off 5 Random Number Remote Reset (RNRR, see section , page 23) Off. An ever-growing list of step by step guides for the most common intruder alarm systems. Bosch, DAS, CADDX, Paradox, Hills and much more. Challenger 10 Cheat Sheet and User Manual. Challenger10 with V8 numbering Chart. Challenger V8 (8) How to Display Time and Date on Challenger Keypad / RAS. CHIME 2 1 (Range - any alarm zone) Enter 2 Enter the keys corresponding to the zone(s) required to chime. On exit from engineer mode zones selected will be set to chime, the customer may disable chime only on zones programmed with this option (see user manual). If no zones are selected the user will not be able to access their chime opt ion.

Subsequent alarms are shown as f ast flashing lights. Zones that were isolated are shown as slow flashing lights. WHILE PANEL IS IN ALARM Go directly to the keypad and insert your user code, the system will disarm, the zone/s will light on the control panel to indicate the cause of the alarm, refer to panel reset to clear.(section). CHIME 2 1 (Range - any alarm zone) Enter 2 Enter the keys corresponding to the zone(s) required to chime. On exit from engineer mode zones selected will be set to chime, the customer may disable chime only on zones programmed with this option (see user manual). If no zones are selected the user will not be able to access their chime opt ion. AP10LED Engineering Manual 5 Section 1 - Overview of System The 10 zone intruder alarm system is an indoor alarm system based on advanced technology to give professional levels of protection and reliability. It is 10 zone wired system with special electronic design for short-circuit protection.